INK STAIN REMOVER - TC6033 Mesh Prep No 3

Technical Information

Properties

TC6033 Mesh Prep No 3 is a cream coloured paste for removing all types of ink stains from both synthetic and stainless steel meshes. A low hazard, caustic free degreaser that enables a completely uniform stencil adhesion, thus enhancing printing properties.
Instructions for use:

1 Dry the screen and apply a small quantity to both sides of the screen with a soft brush.

2 Allow to stand for 30 minutes minimum.

3 Hose or wash off with a high pressure spray.

4 Allow to dry before applying stencil.

Repeat treatment if required.

Mesh Prep No 3 and Antistain:

TC6003 Mesh Prep No 3 when used with TC6017 Antistain or TC6056 Antistain Extra gives optimum properties for the removal of ink and diazo stains.

1 Remove all residues of stain remover.

2 Apply TC6017 Antistain or TC6056 Antistain Extra to both sides of mesh, it is not necessary to rub into the mesh.

3 Allow to dry for at least one hour.

4 Apply TC6003 Mesh Prep No 3 to both sides with a brush.

5 Allow to stand 20-40 minutes.

6 Hose or wash off with a high pressure spray.

Packaging:
TC6003 Mesh Prep No 3 Pack Size: 1 kilo or 5 kilo
Colour: Water White